On-site Ultraprobe training
This training has been designed to familiarise operators with their new Ultraprobe, and covers a wide-range of topics, and can be further tailored as necessary to your specific applications and requirements.
Below is a brief overview of a typical half-day, on-site training session, which we would normally suggest is limited to around four to six people. If you would like to accommodate more people, then we can spend a full day on-site.
The first part of our training is based in the office (e.g. a meeting or training room), and covers the following topics...
- An introduction to ultrasound, and an overview of the equipment.
- Leak detection (both pressure and vacuum leaks).
- Steam trap testing and checking valves.
- Bearing monitoring and lubrication.
- Electrical inspections.
The second part is then based out on-plant (or in a workshop, if that's more convenient), and covers how to actually use the equipment in a typical plant environment. We'll spend time using the Ultraprobe on all of your applications, and each attendee will get a good amount of hands-on time.
In the third and final part of our training, we'll return to the office to discuss what happened during our time on-plant and answer any resulting questions. We will then walk you through any accompanying software and review any data we collected. At the very end, we'll wrap things up with a brief look at other technologies that can compliment an ultrasound programme.
|
 |
|
|
Please contact us for a quotation,
or more information |
|
|
|
| "The course was presented at the right level, and any questions were answered in a professional and informative manner." |
| "The practical session that we had after lunch was of great use." |
Matt Harrison
Centrica Energy |
|
|
|
